Steam Heat & Radiator Repair in Pelham & Pelham Manor: what to know
Nearly every house in Pelham and Pelham Manor was built between about 1900 and 1940, and original one-pipe steam with cast iron radiators is everywhere. These systems can be very comfortable when they are vented and balanced properly, and we spend a lot of time correcting near-boiler piping and venting on replacements done by others.
The local housing stock
Pelham and Pelham Manor are almost entirely 1900s-1930s Tudor, colonial and Shingle-style homes, many with original steam heat, cast iron plumbing and slate roofs, with the Manor's southern edge near the Hutchinson River and Long Island Sound.
Waterfront and flood-prone basements
In low-lying and waterfront parts of Pelham & Pelham Manor, boilers and burners in basements are exposed to flooding and salt air. After a flood, a boiler that took on water should be inspected before it is restarted. Controls, burners and gas valves exposed to floodwater often need replacement. When replacing equipment, we look at raising it or relocating it above flood level.
Mid-century homes with hot water baseboard
The 1940s-1970s colonials, capes and split-levels found across Pelham & Pelham Manor are mostly heated by hot water (hydronic) boilers feeding baseboard or cast iron radiators. Typical problems are waterlogged expansion tanks, failing circulators and zone valves, air in the lines, and boilers that are 25+ years old. These systems are also great candidates for high-efficiency condensing boilers with outdoor reset controls.
Common steam heat & radiator repair calls in Pelham & Pelham Manor
- Some radiators hot, others cold
- Water spitting from radiator vents
- Rusty or murky water in the sight glass
- Frequent low-water shutdowns
- Boiler running long cycles to satisfy the thermostat
Learn more about our full steam heat & radiator repair service, including how we diagnose and what we check.
How a Pelham & Pelham Manor service call works
- Evaluate the whole system
- Balance the system
- Clean and skim
- Set controls correctly
Permits and local requirements in Pelham & Pelham Manor
Work in Pelham and Pelham Manor is permitted through each village's Building Department, under a licensed plumber.
Westchester municipalities each have their own building departments, and most require permits for boiler and furnace replacements. Rental properties are also subject to local housing codes on heat.
What affects the price
- One-pipe vs. two-pipe system
- Number and condition of main vents
- Pipe pitch problems from settling or past renovations
- Near-boiler piping done to manufacturer spec or not
Serving all of Pelham & Pelham Manor
We provide steam heat & radiator repair in Pelham Heights, Pelham Manor, Chester Park, Village of Pelham and ZIP codes 10803.
