Gas Line Installation & Repair in Yonkers: what to know
The hills matter in Yonkers. Homes at the bottom of steep streets can see high water pressure that wears out fixtures and water heaters, while homes near the top sometimes deal with weak pressure through old galvanized lines. Long, steep sewer laterals and decades-old house traps are common on the west side, and the older multifamilies around Getty Square often have original cast iron stacks.
The local housing stock
Yonkers is our home base. It is the fourth-largest city in New York State, built on steep hills above the Hudson, and the housing reflects more than a century of growth: two- and three-family homes in Nodine Hill, Ludlow and Park Hill, prewar apartment buildings along the Getty Square and South Broadway corridors, Tudor and colonial homes in Crestwood, Lawrence Park West and Colonial Heights, and postwar capes and high-rise co-ops on the east side. Because we are local, Yonkers calls get our fastest response times.
Older single-family homes with steam or gravity heat
Homes of this age in Yonkers usually still have some original galvanized supply pipe and cast iron drains. Galvanized pipe closes up with rust from the inside, which causes low pressure upstairs and brown water. Cast iron eventually cracks along the bottom of horizontal runs. We replace these sections selectively or all at once, depending on condition and budget.
Co-op, condo and apartment buildings
In Yonkers's apartment buildings, a leak in one unit is often caused by a riser or fixture in the unit above. We coordinate access between units and with building management, and we schedule riser shutdowns so they disrupt as few residents as possible.
Common gas line installation & repair calls in Yonkers
- Switching from electric to gas range or dryer
- Failed gas inspection
- New boiler, furnace or tankless needs bigger gas line
- Gas smell (leave and call 911 and the utility first)
- Adding a standby generator or outdoor kitchen
Learn more about our full gas line installation & repair service, including how we diagnose and what we check.
How a Yonkers service call works
- Load and sizing
- Permit
- Install and pressure test
- Inspection and turn-on
Permits and local requirements in Yonkers
Plumbing and mechanical work in Yonkers is permitted through the City of Yonkers Department of Housing and Buildings, and work must be performed under an appropriately licensed plumber.
In Westchester County, plumbing work must be performed by a plumber licensed by the Westchester County Plumbing Examining Board (or the applicable city license in cities with their own licensing), with permits filed through the local building department.
What affects the price
- Length of run and number of appliances
- Meter capacity
- Permit and inspection requirements in your municipality
Serving all of Yonkers
We provide gas line installation & repair in Getty Square, Ludlow, Park Hill, Crestwood, Lincoln Park, Dunwoodie, Bryn Mawr, Nodine Hill, Colonial Heights, Sprain Brook, Wakefield Park, Lawrence Park West, Beech Hill, Cedar Knolls, Northwest Yonkers, Runyon Heights, Seminary Heights and ZIP codes 10701, 10702, 10703, 10704, 10705, 10710.
